3/24/2024 0 Comments Fsuipc very unstable![]() ![]() So instead of assigning X axis to the left toe brake, it should say "Left Toe", at least in FSX you can read that and there is no mix. I tried to use FSUIPC but i find it pretty hard to configure ALL Buttons. For the right toe brake, I push it and prepar3d assigns "Axis Y".Īnd the problem comes here: now I configure the yoke, by moving to the left to configure the ailerons, and preapr3d ALSO assigns "Axis X"! So when I press it, it happens both things at the same time and the plane is uncontrollable. Ive set the weather settings for no changes over time, but this does not. I do not want this, Im practicing landings into a 240 degree crosswind. When I get close to the ground, the wind suddenly shifts to a slight tail wind at 10 knots. Maps are calibrated very easily, just mark at least two spots in each of them while you are. So i have been configuring it properly and I found out what happens: When I configure the left toe brake and prepar3d waits for the new assignment, I push the left toe brake and prepar3d assigns "Axis X". I set the wind in advanced settings for 22 knots, gusting to 29 knots at 240 degrees, from zero altitude to 12,000 feet. When i push on the left toe brake, the yoke turn full right and then to full left, and when I push the right toe brake the elevator moves. I really like them but i have a problem that i haven't been able to solve. This is a requirement stated in the consumer law of the EC, point. Hi everyone! I have a saitek yoke and saitek rudder pedals. If you dont support a software for a specific use, you MUST clearly state this in your sales material, respectively point the out the requirements of the software. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |